Re: Yaesu FT-60R/E

Bob Bernardi

Thanks Roger, I’ll check it out

On Dec 23, 2019, at 2:28 AM, Roger McCollough <rkmccol@...> wrote:


The FT-60 can add a PL tone ("T" will appear at the top-center of the display) or Encode/Decode (display will show "T" and "SQ") at the display center.  To do this:

  1. Short press the "FW" key (lower right corner of keyboard) An "F" will appear in the lower left of the display to indicate the keys are in the Function mode (words in red type above each key).

  2. Short press the "1" key labeled "SQ TYP in red; the display will indicate the squelch-type.

  3. Using the tuning knob, selecting "OFF" indicates there is no tone operation, "TONE" indicates Encode only, or "TSQL"                                                                     selects  Encode/Decode operation.  Check the  manual for the other settings.  The FT-60 does not support Decode only.

  4. Short press the PTT button to clear from Squelch-type.

  5. Repeat step 1.

  6. Short press the "2" key (the word Code is written in red above the key) and rotate the tuning knob to select the desired tone

  7. Press the "FW" key again to save the change.  Note: this is NOT saved in permanent memory. 

I think this is the answer you are looking for, BUT if further info is needed, contact me and I'll try to help.

Roger Mc



Sn 12/18/2019 8:38 PM, Bob Bernardi via Groups.Io wrote:
Hi all

I have a Yaseu FT-60R/E. I am trying to program it the Papa analog repeaters but I can not figure out how to put in separate CTCSS encode and decode freqs. Is this even possible? If not can I use it with repeaters with separate frequencies. 

Thanks in advance

P.S. Happy Holidays to you and your kin.

Join to automatically receive all group messages.